Cabling; Cable Connector And Method Of Using Bafang Tool - BAFANG MM G333.250.C Manual

6.3.3 Cabling

Steps:
1) Link the female connector (8 pin) for EB-BUS "d" to the male connector (8 pin) at the drive unit "D".
2) Link the male connector (8 pin) for EB-BUS "c" to the female connector (8 pin) at the drive unit "C".
3) Link the power connectors together.
Note: Whether link 6 pin EB-BUS to drive unit is based on customer functional requirements.

6.3.4 Cable connector and method of using BAFANG tool

Steps:
1) Hold the cable connector with left hand.
2) Insert BAFANG tool into the bottom of the cable connector with right hand.
3) Insert BAFANG tool clockwise to make both fit together tightly.
4) Insert the unit into the corresponding position at the drive unit.
5) After inserting it into place, turn BAFANG tool counterclockwise and take it out.
BF-DM-C-MM G333-EN November 2019
Male connector for power supply at the
A
drive unit
a Female connector for power supply at the
battery
Male connector (6 pin) at the drive unit
B
Female connector (6 pin) for other device
b
Female connector (8 pin) at the drive unit
C
c Male connector (8 pin) rear BUS cable
Male connector (8 pin) at the drive unit
D
Female connector (8 pin) at the front BUS
d
cable
7