Installing The Scanner Software - Epson GT-10000 User Manual

6. When you see the screen on the right
prompting you for the location of the
driver, check
Browse to the following location on
the CD-ROM:
Then click
(The example screen shows D as
the CD-ROM drive letter; your
CD-ROM drive letter may be
different.)
7. The necessary driver files are copied to your hard drive, then you see a prompt to
restart your system. Be sure to close any open windows, then click
8. After the system restarts, log on again. Windows NT auto-detects the scanner.
9. To verify that the SCSI board was detected, click
, and double-click
Panel
necessary. You should see your
to close the dialog box.
OK
Continue with the instructions on page 29 to install your scanner software.

Installing the Scanner Software

Before you begin installing software, make sure you recalibrate your monitor to
factory specifications. Then follow the instructions for your operating system:
If you're running Windows 98, continue with the next section, "Installing the
Software for Windows 98."
If you're running Windows 95, go to "Installing the Software for Windows 95"
on page 24.
If you're running Windows NT 4.0, go to "Installing the Software for Windows
NT 4.0" on page 29.
For instructions on installing software for a network scanner, go to Chapter 5,
"Network Scanning."
18
Setting Up Your Scanner
Specify a location
Adaptec\Ezscsi
.
Next
SCSI Adapters
.
.
Start
. Then click the
Adaptec PCI SCSI Controller
to restart.
Yes
, ,
Settings Control
tab, if
Devices
in the list. Click