Unlocking the Scanner
Before connecting the scanner
to a power source, you must
release the transportation lock,
located on the left side of the
scanner.
Use a coin or large flat-head
screwdriver to turn the
transportation lock to the
unlocked position, as shown.
Always lock the transportation lock before moving the
scanner. Also, be sure the scanner lamp is in the home
position (on the left side of the scanner). See "Transporting
the Scanner" on page 100 for more information.
Setting the SCSI ID Number
The scanner's SCSI ID number default
setting is 2. If you need to change this
number, turn the SCSI ID dial on the
back panel. Be sure to choose a unique
number that doesn't conflict with the
ID number of other SCSI devices.
Don't use SCSI ID 7, which is usually
reserved for the SCSI interface in the
computer. SCSI ID 0 and 1 are also
not recommended, as these may be
used for the hard disk.
unlocked position
Setting Up Your Scanner
11