Installing The Software For Windows Nt 4.0 - Epson GT-10000 User Manual

To make sure your scanner driver is installed correctly, verify that the scanner is listed
in the Windows Device Manager. (Click
double-click the
System
EPSON Scanners
If you're done installing software, restart your computer. If you want to install
PhotoDeluxe and TextBridge Pro, see page 33.

Installing the Software for Windows NT 4.0

Follow the instructions in this section to install the EPSON GT-10000 scanner driver
and other software on your scanner software CD-ROM. Before you begin installing
software, make sure you recalibrate your monitor to factory specifications. (See your
monitor documentation for instructions.)
You may be asked to insert your Windows CD-ROM during this procedure.
Make sure you have your Windows CD-ROM available, or know where to find the
Windows source files on your hard drive. If you need help locating your source files,
contact your computer manufacturer.
If you want to use your scanner on a network, go to Chapter 5, "Network Scanning,"
instead.
1. Make sure your SCSI board and SCSI driver are installed and the scanner is
connected to your computer.
2. Turn on your scanner first, then turn on your computer.
3. Log onto Windows NT and insert your EPSON GT-10000 Scanner Software
CD-ROM in your drive.
icon. Select the Device Manager tab and double-click
. should appear in the list.)
GT-10000
, ,
Start Settings Control Panel
, then
Setting Up Your Scanner
29