Table of Contents
Advertisement
Removing the full length expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the GPU air shroud top
4. If applicable, disconnect the cables from the expansion card or system board.
5.
NOTE:
If BOSS-N1 module is installed, ensure to disconnect the BOSS-N1 power cable and Signal cable before removing
the Riser 1 cage.
Steps
1. To remove full length expansion card riser:
a. Loosen the captive screws on the riser.
b. Press the blue release tab and holding the edges, lift the expansion card riser from the riser connector on the system
board.
c. Disconnect the GPU power cable and signal cable from the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
194
Installing and removing system components
Safety
instructions.
Before working inside your
cover.
system.
Advertisement
Table of Contents
