Removing The Full Length Expansion Card Risers - Dell EMC XC Core XC7525 Installation And Service Manual

Figure 78. Removing the filler bracket
3. Hold the card by its edges, and align the card edge connector with the expansion card connector on the riser.
4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
5. Close the expansion card retention latch.
6. Push the black card holder to hold the card in the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 79. Installing an expansion card into the expansion card riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Removing the full length expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
After working inside your
Safety instructions.
system.
Installing and removing system components 85