Removing A 2 X 2.5-Inch Rear Drive Module Cooling Fan - Dell PowerEdge R7625 Installation And Service Manual

Figure 46. Installing a cooling fan
Next steps
1. If removed, install the air shroud
2. Follow the procedure listed in

Removing a 2 x 2.5-inch rear drive module cooling fan

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the 2 x 2.5-inch rear drive module air
Steps
Press the orange release tab and lift the rear drive module cooling fan to disconnect from the connector on the rear drive
module.
WARNING: Ensure not to tilt or rotate the cooling fan while removing from the rear drive module.
or install the GPU air shroud.
After working inside your
Safety instructions.
Before working inside your
shroud.
system.
system.
Installing and removing system components 87