Removing The Full Length Expansion Card Risers - Dell EMC Core XC750 Installation And Service Manual

Next steps
1. If applicable, connect the cables to the expansion card.
2. Replace the expansion card
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.

Removing the full length expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the GPU air shroud top
4. If installed, remove the GPU air shroud
5. If applicable, disconnect the cables from the expansion card or system board.
NOTE: Full length risers are supported only in Riser 1 and Riser 4 slot.
Steps
1. To remove full length expansion card riser:
a. Loosen the captive screws on the riser.
b. Disconnect the GPU power cable from the system board.
c. Press the blue release tab and holding the edges, lift the expansion card riser from the riser connector on the system
board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 128. Removing the expansion card riser (Riser 1)
riser.
After working inside your
Safety instructions.
Before working inside your system
cover.
filler.
system.
Installing and removing system components 123