Table of Contents
Advertisement
Releasing the brakes
Only transfer into or out of the electronic
travelling wheelchair when the electronic
travelling wheelchair is switched off and the
selection lever drive-/push mode on both
sides is in drive mode!
Inadvertently knocking the joystick will set
the electronic travelling wheelchair in mo-
tion without control! – Danger of accidents!
To loosen the brakes press the selection lever
drive-/push mode on both sides forward as far
as possible into push mode [2 on page 39].
☞ Activation of the selection lever is intend-
ed for an accompanying person.
Drive-/push mode
Only switch the electronic travelling wheel-
chair to push mode when it is standing still
for positioning or in case of emergencies, but
not on slopes/hills.
After push mode do not forget to switch the
drive back to drive mode. Otherwise there
is the danger of your electronic travelling
wheelchair unintentionally rolling off.
Selecting the push mode
1.
Switch off the operating module because
the pushing will otherwise be made diffi-
cult by the electric system.
☞ Therefore observe chapter Operating
module-functions on page 10.
2. Disengage the brakes [2 on page 39].
☞ Therefore observe chapter Releasing
the brakes on page 10.
☞ The electronic travelling wheelchair
can now be pushed.
10
Selecting the motor mode
1.
Activate the brakes [1 on page 39].
☞ Therefore observe chapter Locking the
brakes on page 9.
2. Switch the operating module on.
☞ Therefore observe chapter Operating
module-functions on page 10.
The electronic travelling wheelchair is now
ready for use.
OPERATING
MODULE-FUNCTIONS
Battery charging socket
Do not insert other objects into the battery
charging socket. – Danger of short circuit!
To charge the lithium ion batteries first switch
off the operating module. Then insert the plug
of the battery charger into the charging socket
(3 on page 39) on the front of the operating
module.
Switching the operating module on
Do not move the joystick during the system
test.
Press the ON/OFF key to switch on the oper-
ating module (4 on page 39). The electronic
system now performs a system test.
☞ The electronic system is ready when the
battery gauge (5 on page 39) is perma-
nently lit.
Battery voltage
The battery indicator displays the battery volt-
age after the system test performed by the
electronic system after the operating module
has been switched on (5 on page 39).
Less LED segments of the battery gauge are lit
as the battery voltage reduces.
Advertisement
Table of Contents
