Epson Stylus Pro 7700/7710/9700/9710
Cleaning the Printer
To keep your printer in top operating condition, clean
it thoroughly if it becomes soiled.
Caution:
c
Take care to prevent water or other foreign
matter getting inside the printer. If moisture,
dirt, or other matter gets inside of the printer,
besides affecting print quality, it may cause the
electric circuits to short.
Cleaning outside of the printer
A
Remove the paper from the printer.
B
Make sure the printer is turned off and all the
lights are off, and then unplug the power cord
from the electrical outlet.
C
Use a soft, clean cloth to carefully remove any
dust or dirt.
If the dirt does not come off, clean it using a
soft, clean cloth dampened with a mild
detergent. Then, wipe the outside of the printer
with a dry, soft cloth.
Caution:
c
Never use alcohol or thinners to clean the
printer; these chemicals can damage the
components as well as the case.
User's Guide
Maintenance
Cleaning inside of the printer
If the print gets a scratch or smudge, follow the steps
below to wipe off the smudge inside of the printer.
Cleaning the roller
If the print is soiled by ink on the roller, follow the
steps below to clean the roller by feeding the plain paper.
A
Turn on the printer, and set the roll paper.
Set the roll paper of 44-inch width for Epson
Stylus Pro 9700/9710 and 24-inch width for
Epson Stylus Pro 7700/7710.
B
Press the
Repeat step 2 for a few times until the paper is not
soiled with ink.
Cut the paper after cleaning is done.
See "Cutting the roll paper" on page 33
Cleaning inside
A
Make sure the printer is turned off and all the
lights are off, and then unplug the power cord
from the electrical outlet.
B
Leave the printer for a minute.
82
See "Using Roll Paper" on page 29
button to feed the paper.