Epson Stylus Pro 7700 User Manual page 47

Epson Stylus Pro 7700/7710/9700/9710
Taking up your prints
When the Auto Take-up Reel Unit is installed, and the
take-up reel core is loaded with paper to take up in the
desired direction, you can use the unit to take up your
prints.
Warning:
w
Do not touch the Auto Take-up Reel Unit while
it is operating. Doing so may result in injury.
A
Set the Auto switch to Forward or Backward.
B
Send a print job to the printer.
The printer starts printing. The Auto Take-up
Reel Unit takes up the roll paper in the
direction you set in step 1.
Note:
When printing by using the Roll Auto Cut On
set the Auto switch of the Auto Take-Up Reel Unit to
Off, otherwise the printer does not cut the paper. You
can set the Auto switch to Off during printing to cut
the paper automatically.
User's Guide
Paper Handling
Removing paper after take-up
After paper take-up, follow the steps below to remove
the take-up reel core.
A
Set the Auto switch to Off.
B
Cut the roll paper.
❏ Press the
❏ If the roll paper cannot be cut with the
C
Turn the lever to unlock the movable unit, and
then slide it to the left so that the flange knob
clears the end of the take-up reel core.
While doing this, support the take-up reel core
with one hand to keep it from falling.
,
47
button to cut the roll paper.
built-in cutter, use a scissors or cutter sold
at a store.