Copy Setting Menu - Epson AcuLaser CX37DN Series User Manual

SUPPLIES FUSER UNIT
REPLACE
*1
This menu item appears when ADMIN. MANAGEMENT/NETWORK SETTING/TCP/IP is set to ENABLE.
*2
This menu item appears when ADMIN. MANAGEMENT/NETWORK SETTING/IPv6/DISABLE/ENABLE is set to ENABLE.
*3
This menu item appears when ADMIN. MANAGEMENT/E-MAIL SETTING/POP BEFORE SMTP/DISABLE/ENABLE is set to
ENABLE.
*4
This menu item appears when ADMIN. MANAGEMENT/E-MAIL SETTING/SMTP AUTH./DISABLE/ENABLE is set to
ENABLE.
*5
This menu item appears when ADMIN. MANAGEMENT/LDAP SETTING/DISABLE/ENABLE is set to ENABLE.

COPY SETTING Menu

Note:
Manufacturer's default settings appear in bold.
PAPER PRIORITY
TRAY CHAINING
QUALITY PRIORITY
DENSITY PRIORITY
Epson AcuLaser CX37 Series
Settings TRAY1 / TRAY2 / TRAY3
Specify the paper tray that is normally used.
Note:
If an optional 500-Sheet Paper Cassette Unit is not installed, TRAY3 does not appear.
Settings
DISABLE / ENABLE
If ENABLE is selected and the specified tray runs out of paper during printing, a tray
loaded with paper of the same size is automatically selected so printing can continue.
If DISABLE is selected and the specified tray runs out of paper, printing stops.
Settings
MIX / TEXT / PHOTO / FINE/MIX / FINE/TEXT / FINE/PHOTO
Select the type of document being copied.
Note:
❏
When a document is loaded into the ADF, the default setting MIX is automatically
selected.
❏
For the resolution of each setting, refer to "Resolution of QUALITY PRIORITY
Settings" on page 64.
Settings AUTO / MANUAL
Select the density that is normally used.
Printer/Copier/Scanner User's Guide
Replace the counter when the fuser unit is replaced with
new one.
Control Panel and Configuration Menu 63