Processor Heat Sink Module (Phm) Assembly; Figure 105. Processor Carrier Clip Removal From Phm Assembly; Figure 106. Installing Processor Carrier Clip Onto Processor-Part 1 - Intel M50FCP2UR Integration And Service Manual

Intel® Server System M50FCP2UR System Integration and Service Guide

Figure 105. Processor Carrier Clip Removal from PHM Assembly

12. Return the lever to the original position (see Letter C).
13. Unlatch the tab on each corner of the processor carrier clip to release it from the heat sink (see Letter
D).
14. Lift the processor carrier clip up and away from the heat sink (see Letter E).
6.6.2

Processor Heat Sink Module (PHM) Assembly

The procedures described in the following sections must be followed in the order specified to assemble the
PHM and install it on to the server board. These instructions assume that the Thermal Interface Material (TIM,
Honeywell* PTM7000) is already applied to the bottom of the heat sink.
Caution: Wear ESD gloves to prevent electrostatic damage and oxidation or foreign material on processor
package and land pads.
Figure 106. Installing Processor Carrier Clip onto Processor–Part 1
1. Position the Pin 1 indicator of the carrier clip with the Pin 1 indicator of the processor (See
106).
2. With the processor still on its shipping tray, place the processor carrier clip over the processor.
82
Figure