Figure 45. 2.5" 7 Mm Drive Outside Chassis, Ready For Installation; Figure 46. 2.5" 7 Mm Drive Installation Into 2.5" Drive Bay - Intel M50FCP2UR Integration And Service Manual

Intel® Server System M50FCP2UR System Integration and Service Guide
3.6.1.3 2.5" SSD Drive Installation
Front drive bays can support SSDs with a height of 7mm or 15mm. With the SSD mounting bracket attached
to the 7mm drive, installation into the front drive bay is the same for both drive sizes. Note the location of
the drive interface connector before installing the drive into the drive bay. Ensure its orientation matches
with the interface connector on the backplane.

Figure 45. 2.5" 7 mm Drive Outside Chassis, Ready for Installation

1. Ensure that the drive extraction lever is in the open position, and the drive rail is pulled out as far as
possible.
2. Align and insert the drive into the drive bay. See Letter A.
Note: Intel recommends holding the drive with one hand while holding the lever with the other hand.
3. Slide the drive into the drive bay until it is fully seated within the drive interface connector on the
backplane (see Letter B).
4. Close the drive extraction lever until it locks into place. See Letter C
46

Figure 46. 2.5" 7 mm Drive Installation into 2.5" Drive Bay