Measuring Gated Power - Agilent Technologies 8960 Series Operation Manual

Measuring Gated Power

These measurements can be made only when one of the following radio
configurations (see
• (Fwd1, Rvs1)
• (Fwd2, Rvs2)
1. Select the Gated Power measurement (see
2. Press the ( ) key to select Zoom.
F4
3. Turn the knob clockwise slowly to display the entire burst. Note the falling edge of
the burst at the last zoom position on the right side of the display.
4. Press the ( ) key to select the Rise/Fall View.
F2
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started
"How Do I Set Up a Call?" on page
cdma2000 Measurement Procedures
52) is selected:
"B. Select measurements." on page 48).
83