Table of Contents
Advertisement
Help Guide
Multi Channel AV Receiver
STR-AZ7000ES/STR-AZ5000ES/STR-AZ3000ES
Outputting a test tone from each speaker (Test Tone)
You can output a test tone from each speaker in sequence.
Select [Setup] - [Speaker Settings] from the home menu.
1
2
Select [Manual Speaker Settings].
Select [Test Tone].
3
Select the setting you want.
4
Off
Auto: The test tone is output from each speaker in sequence.
Front (L), Center 1 (*1), Center 2 (*1), Center (*2), TV Center, Front (R), Front Wide (L) (*3), Front Wide (R) (*3), Surround (L), Surround (R), Surround Back (L),
Surround Back (R), Height1 (L), Height1 (R), Height2 (L), Height2 (R), Height3 (L) (*3), Height3 (R) (*3), Top Front (L) (*3), Top Center (*3), Top Front (R) (*3), Top
Rear (R) (*3), Top Rear (L) (*3), Bottom Front (L) (*3), Bottom Center (*3), Bottom Front (R) (*3), Subwoofer: You can select which speakers will output the test tone.
*1
for STR-AZ7000ES/STR-AZ5000ES
*2
for STR-AZ3000ES
*3
for STR-AZ7000ES
Adjust the speaker level.
5
Hint
You can set a test tone by pressing the TEST button on the remote control. In this case, you can only use the display panel for the operation.
To adjust the level of all speakers at the same time, press
The adjusted value is shown on the TV screen during adjustment.
(volume) +/–. You can also use MASTER VOLUME on the receiver.
5-037-021-11(1) Copyright 2022 Sony Corporation
214
Advertisement
Chapters
Table of Contents
