The lower line of the display panel will change sequentially as follows each time you press DISPLAY: currently applied sound field (*1) - stream information (*2) - default input

name (*3).

When listening to FM radio

The band, preset number, and preset station name (*4) or frequency are displayed on the upper line of the display panel.

The currently applied sound field is displayed on the lower line of the display panel.

When receiving BLUETOOTH audio

[BLUETOOTH] is displayed on the upper line of the display panel.

The currently applied sound field or connected device name is displayed on the lower line of the display panel.

[PURE DIRECT] appears on the display panel when the Pure Direct function is activated.

Stream Information is not displayed when no signals can be found for the selected input.

Appears only when you have set an arbitrary input name.

Appears only when you have set an arbitrary preset station name. In this case, the preset station name and frequency are displayed alternately each time you press DISPLAY.

Checking the information of a connected BLUETOOTH device

You can check the BLUETOOTH device information by pressing DISPLAY on the receiver repeatedly. Each time you press DISPLAY, the display will change cyclically as follows:

During BLUETOOTH RX mode: Input you are selecting - BLUETOOTH device name - Sound field currently applied - Volume level

During BLUETOOTH TX mode: BLUETOOTH device name - Sound field currently applied - Volume level - Input you are selecting

Hint

To set this function to [Off], press AMP MENU and ENTER on the receiver at the same time.