Understanding The Leds - Nortel 600 Installing

3
Plug the other end of the power cord into a surge protector.
4
Plug the surge protector (or the power cord) into the power outlet.
The Contivity 600 should begin to boot.
5
Verify a successful installation by checking the LEDs on the front panel (see
"Front panel LEDs" on page
If the Ready LED does not turn green (to indicate that the gateway has booted
successfully), check that the power cord is properly attached to the power supply
pack and to the power outlet.
If the Contivity 600 still does not boot, contact your local Nortel Networks
Technical Solutions Center (see

Understanding the LEDs

This section describes the LEDs on the front panel of the Contivity 600 and on the
interface cards that have LEDs. You can confirm that the LAN and WAN
interfaces are cabled properly by examining the LEDs.
Chapter 2 Cabling the gateway and turning the power on 25
Caution: You should protect the Contivity 600 by plugging it into a
surge suppressor.
Note: The Contivity 600 has no power switch. Connecting the Contivity
600 to a power supply turns the gateway on.
26).
"How to get help" on page 16).
Installing the Contivity 600