Transportation, Storage And Disposal - Husqvarna LB 448iV Operator's Manual

Battery charger
LED on the battery
charger
The error LED flashes
or comes on.
Control panel
Error code (Number
of flashes)
1
5
8
9
10
Other errors
Introduction
WARNING:
during transport and storage remove the
safety key, remove the batteries and wait a
minimum of 5 seconds.
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
• For commercial transports special requirements on
package and labels must be obeyed.
18
Cause
The battery charger is
too cold or too hot to
use.
Other errors.
Possible faults
The transmission motor is too hot.
The motor speed decreases too much, and
the motor stops.
The battery is weak.
Battery error or no signal from battery.
The motor control is too hot.
If other errors occur, remove the safety key and the battery and speak to your Husqvarna
servicing dealer.

Transportation, storage and disposal

To prevent accidental start
Solution
Let the battery charger cool down or move it indoors to warm
it up. When the battery charger has the correct temperature, it
can be used again. Use the battery charger when the ambient
temperature is 5 °C–40 °C.
Speak to your Husqvarna servicing dealer.
Possible procedure
Let the product become cool. Make sure that
the transmission does not have grass on it.
Clean the transmission cover if it is necessa-
ry.
Clean the cutting deck and increase the cut-
ting height. Refer to
on page 14 . If the error stays, speak to your
Husqvarna servicing dealer.
Charge the battery. Refer to
battery on page 14 .
Put the battery in the product correctly and
examine the battery connector. If the error
LED on the battery flashes, refer to
on page 17 .
Stop the motor and wait until it is cool.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
• Put tape on the battery connectors and make
sure that the battery cannot move around during
transport.
• Attach the product during transport.
Storage
• Always remove the batteries for storage.
• Let the product become cool before storage.
• To prevent accidents, make sure that the battery is
not connected to the product during storage.
To set the cutting height
To charge the
Battery
2168 - 002 - 28.11.2023