Information And Warning Messages - Husqvarna Automower 405X Operator's Manual

6.3 Information and warning messages

The information messages in the table below are shown in the display of the product. Speak to your Husqvarna
representative if the same message shows frequently.
Message Cause
Limited cutting height The cutting height adjustment cannot move.
Unexpected cutting
height adj
Limited cutting height
range
Cutting height prob-
lem
Cutting height
blocked
GPS navigation prob- Problem with the GPS assisted navigation
lem
equipment.
Weak GPS signal
The sky is blocked in large parts of the work
area.
Low battery The product cannot find the charging station.
The battery is at the end of its life cycle.
The antenna of the charging station is defec-
tive.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Settings restored Reset all user settings has been done.
A
Guide not found
The guide wire is not connected to the charg-
ing station.
Damage in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Connection changed
New loop signal changed.
40 - Troubleshooting
Action
Examine the cutting height adjustment and
remove grass or other objects. If the problem
stays, speak to your approved servicing deal-
er.
Speak to your local Husqvarna representa-
tive if this message appears often.
Remove objects that can cause a blockage
of the GPS signal.
Disable the GPS navigation function and use
Lawn coverage function. Refer to GPS
the
Assisted Navigation, Lawn Coverage and
Systematic Passage Mowing on page 25 .
Change the position of the guide wire. Refer
To install the guide wire on page 20 .
to
Replace the battery. Refer to
page 35 .
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
lamp in the charging station on page 41 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your approved servicing dealer.
Usual operation of the product.
Connect the guide wire to the charging sta-
To install the guide wire on
tion. Refer to
page 20 .
Replace the damaged section with new
guide wire.
Connect the guide wire correctly to the boun-
dary loop. Refer to To install the boundary
wire on page 20 .
Usual operation of the product.
1650 - 003 - 24.02.2021
Battery on
Indicator