Table of Contents
Advertisement
14. Submit the changes by pressing Control E (i.e. the "Ctrl" Key and the E
Key together). The Main Menu should now be displayed. The message
"Please use the Save command" will also appear in the middle of the fifth
line up from the bottom of the screen.
15. Type SAVE<CR> at the Command Line prompt. The word SAVE will
disappear after a few seconds and the message "Please use the save
command" will also disappear.
16. Type CO PA<CR> at the Command Line prompt. The "Configure Paths
Menu" should now be displayed with the LAN01 Path highlighted.
17. Type ED<CR> at the Command Line prompt. The "Update Path Form"
should now be displayed.
18. Change the IPAddr&Mask parameter from "1.1.1.1" to 192.168.0.1/24.
19. Change the IPX NetworkEtherII parameter from "00000000" to
00DADD1E.
20. Change the IPX Mode from "802.3" to "EtherII" if using Version 1 or
Version 2 Router S/W, or change from "Auto" to "EtherII", if using V3
Router S/W.
Note as there are no Novell Servers on the LAN at the remote office the IPX
Mode option "Auto" cannot be used, and the Novell Frame Type on use on the
T
UTORIAL
3-51
Advertisement
Table of Contents
