Table of Contents
Advertisement
The "RADIUS Configuration Parameters" form should now be exactly the
same as that shown below.
36. Submit the changes by pressing Control E. The Main Menu should now
be displayed. The message "Please use the Save command" will also
appear in the middle of the fifth line up from the bottom of the screen.
37. Type SAVE<CR> at the Command Line prompt. The word SAVE will
disappear after a few seconds and the message "Please use the save
command" will also disappear.
38. Type CO IP<CR> at the Command Line prompt. The "Configure IP
Routes Menu" should now be displayed with the IP Route with Id equal to
1 highlighted.
39. Type AD S<CR> at the Command Line prompt. The "Update IP Route
Form" should now be displayed.
40. Change the IP Address parameter from "0.0.0.0" to 192.168.0.0/24.
41. Change the Path parameter from "LAN01" to "VirtualPath".
42. Change the Metric parameter from "1" to 14.
T
UTORIAL
3-41
Advertisement
Table of Contents
