Installing Erpcd - Bay Networks 5000 Installation Manual

:acp:/usr/annex/acp_passwd
where the filename following :acp: is the full pathname of the
acp_passwd file.
The script displays the status of updated file copies (if any). Then the
script prompts you to install the updated files.
Copies of the following files have been updated:
eservices
services
Do you want to install any of these files (y/n) [y]
6. Press Return to install the files, or n to finish the installation.
NOTICE: NIS was found to be running.
You must update the NIS services database manually.
As a guide use the services listed in file save/
modified/services.
The following files/databases remain to be updated:
services

Installing Erpcd

If the script detects erpcd (expedited remote procedure call daemon), it
prompts you to start up the new erpcd, or keep running the old erpcd.
If you specify a directory other than the default, you must
specify that directory when starting erpcd. See
on page 3-2 for more information.
There is an erpcd daemon already running.
Do you want to kill the daemon and start up the new
version? (y/n) [y]:
7. Press Return to load the new erpcd.
It takes a few minutes to start up the new version of erpcd, during
which time erpcd services are unavailable. After the new erpcd
starts, the script notifies you that it is done.
Starting-up the new version of the erpcd daemon.
Annex Software Installation Script
Installing Remote Access Concentrator Software for UNIX
Chapter 2 Installing the Software
Starting erpcd
2-11