Table of Contents
Advertisement
BASIC SETUP
These instructions are intended to provide the basic settings to get the equipment started.
CompleteStat
Navigate the menus and change settings by pressing a
combination of the four arrow buttons and the ENTER
button.
•
ENTER button to select and/or exit value editing
UP or DOWN button to move among entries
•
•
RIGHT or LEFT button to move among value fields
•
LEFT button to return to the home screen
NOTE: Although cooling/heating setpoints can be
accessed by simply pressing the UP or DOWN
buttons during normal operation, any changes
made in this fashion will not be permanent
but last only for a specific length of time as an
"override" feature. See Temperature Setpoints
on page 8 for further information.
QUICK START PROGRAMMING
System Selection
To select A/C or HP, stages of heating and cooling, and
with/without economizer:
1. Press RIGHT button to access Main Menu screen.
2. Press DOWN button to scroll to ADVANCED. Press
ENTER button.
3. In the ADVANCED menu screen, press ENTER
button to enter the APPLICATION menu.
4. Controller will ask for Admin Level Password. Enter
BARD or 1914. Press ENTER button.
5. Press ENTER button to choose DEGREES SCALE
(if neccessary).
FIGURE 1
Buttons and Home, Overide and Configuration Screens
TM
NOTE: The APP category must be set to "NOT
6. Press UP or DOWN button to choose °Fahrenheit or
NOTE: The change from F to C will not take effect
7. Press DOWN button to scroll to APP. Press ENTER
8. Press UP or DOWN button to choose from
10. Press DOWN button to scroll to OPT. Press ENTER
11. Press UP or DOWN button to choose from the
NOTE: These are stages of compressor operation.
12. Press ENTER button to select/save appropriate
13. Press DOWN button to scroll to ADDITIONAL
BASIC OPERATION
CONFIGURED" before the controller will allow
the scale to be changed.
°Celsius. Press ENTER to save selection of scale.
on the home screen until the 24VAC power is
cycled off and back on.
button.
the available System types (A/C, HP or Not
Configured). Press ENTER button to select/save
appropriate choice.
button.
following available System Stages:
•
A/C – 1H/1C
HP – 1 Stage
•
A/C – 2H/2C
HP – 2 Stages
•
A/C – 1H/2C
•
A/C – 2H/1C
This setting does not include ECON as a
cooling stage.
model stage.
SETUP. Press ENTER button.
Manual
2100-566F
Page
5 of 24
Advertisement
Table of Contents
