Wds Settings - Nortel 120 Using Manual

VLAN
VLAN Classification—Enables or disables VLAN tagging support on the
access point.
Native VLAN ID—The VLAN ID that traffic must have to be able to manage
the access point. (Range 1-4094; Default: 1)

WDS settings

Each access point radio interface can be configured to operate in a bridge or
repeater mode, which allows it to forward traffic directly to other access point
units. To set up bridge links between access point units, you must configure
the wireless Distribution System (WDS) forwarding table by specifying the
wireless MAC address of all units to which you want to forward traffic. Up
to six WDS bridge or repeater links can be specified for each unit in the
wireless bridge network.
The Spanning Tree Protocol (STP) can be used to detect and disable
network loops, and to provide backup links between bridges. Using the
STP, a wireless bridge can interact with other bridging devices (that is, an
STP-compliant switch, bridge or router) in your network to ensure that only
one route exists between any two stations on the network, and provide
backup links, which automatically take over when a primary link goes down.
Copyright © 2006, Nortel Networks
.
BAP120
Using the Nortel Business Access Point 120
NN47921-301 01.01 Standard
1.0 August 2006
WebUI navigation 59
Nortel Networks Confidential