Configuring The Network; Procedure Job Aid - Nortel 120 Using Manual

Configuring the network
Use one of the following network topologies to connect wireless clients, the
BAP120, and wired LANs:
•
•
•
•
Procedure steps
Step
1
2
3
4
5

Procedure job aid

Wireless networks support a stand-alone configuration as well as an
integrated configuration with 10/100 Mb/s Ethernet LANs. The Business
Access Point 120 also provides repeater and bridging services that can be
configured independently on either the 5 GHz or 2.4 GHz radio interfaces.
Copyright © 2006, Nortel Networks
.
"Infrastructure wireless LAN" (page 14)
"Infrastructure wireless LAN for roaming wireless PCs" (page 15)
"Infrastructure wireless bridge" (page 16)
"Infrastructure wireless repeater" (page 17)
Action
Determine which of the four valid network topologies is the best
configuration for your site.
Assemble the required cabling for your chosen topology.
Determine which system configuration values must be changed from
the factory default settings to support your chosen topology. The
"Infrastructure wireless LAN" (page 14)
are listed in "System defaults" (page
Delay making the changes to the default values until after you
have initially installed the BAP120. For further information, see
"Configuring the BAP120 the first time it is powered up" (page
Connect the BAP120 to your LAN through the RJ-45 port.
Using the Nortel Business Access Point 120
NN47921-301 01.01 Standard
1.0 August 2006
18).
—End—
BAP120
uses the default values that
Nortel Networks Confidential
33
35).