Avoiding Canceling Due To Cleaning During Printing; Cleaning During Printing - Roland TrueVIS MG-640 User Manual

Avoiding Canceling Due to Cleaning during
Printing

Cleaning during Printing

This machine counts the hours of printing, and when the accumulated printing hours reach a specified
time, automatic cleaning is performed. When cleaning finishes, the accumulated printing time is reset.
This cleaning is performed during printing, so print quality may be affected.
To avoid cleaning during printing, first obtain the time until cleaning is performed. Next, use the software
RIP to confirm the required time for printing. If the required time for printing is greater than the time
until cleaning, perform normal cleaning prior to printing. This will cause the accumulated printing time to
be reset. Alternatively, change the print quality to reduce the time required for printing. Either of these
methods can be used to prevent cleaning from being performed while printing is in progress.
1. Confirm the accumulated printing time.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the following screen.
MENU
SUB MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
SUB MENU
TIME TO CL.
4.
Press [▶] to display the following screen.
TIME TO CL.
SHOW
5.
Press "▲" or "▼" to select "SHOW".
6.
Press [ENTER] to confirm your entry.
7.
Load the media to display the screen shown below.
The time until cleaning is performed is displayed on the screen after "CL.".
W1600mm
CL.: 60min
MEMO
Default setting: "HIDE"
192
Optimizing the Output Quality
HIDE