Table of Contents
Advertisement
Step 3: Preparations for Cutting Output
After printing crop marks and performing post-processing such as laminating, load the media again. Use
this section to check the settings required for cutting output.
1. Loading Media with Crop Marks
Procedure
1.
Load the media on which crop marks have been printed.
Place the front left and right crop marks so they are straight and aligned with the blade protector
(A).
IMPORTANT
Ensure that the crop marks are not angled by more than 5 degrees. Crop marks cannot be read at higher an-
gles.
2.
Complete the setup of the media.
RELATED LINKS
・
P. 30Setup of Media
Cutting with Crop Marks
How to Cut with Crop Marks
137
Advertisement
Table of Contents
