Step 2: Starting Output - Roland TrueVIS MG-640 User Manual

Step 2: Starting Output

WARNING
Never touch the print-head carriage while output is in progress.
The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause injury.
Procedure
1.
Before the start of daily operations, remove just the white ink cartridge, shake it 50 times (about 20 sec-
onds), and then reinsert it.
So that the ink mixes well, shake the ink cartridge horizontally with a stroke length of around 5 cm
(2 in.) from each end of the ink cartridge.
IMPORTANT
The ingredients in white ink tend to settle. The precipitation of the ingredients in the ink disables printing in
normal color. Allowing the ink to stand can cause the settled material to harden, resulting in malfunction or
other problems.
2.
Close the front cover.
3.
Check that [SETUP] is lit.
If [SETUP] is not lit, the setup is not completed. Lower the loading lever, and then press [ENTER].
4.
Check that the screen shown below (the top menu) is displayed.
If the top menu is not displayed, press [MENU].
W 1600mm
5.
Send the output data from the computer.
For information on how to create the output data, refer to the documentation for the software RIP.
Printing and Cutting Output
Printing and Cutting Method
113