Roland TrueVIS MG-640 User Manual page 105

Printing and Cutting Output
4. Adjust the misalignment of the ink landing position.
Procedure
1.
Press [◀] to select "SET".
MEDIA GAP ADJ.
[SET]
2.
Press [ENTER] to confirm your entry.
Printing of the test pattern starts.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
3.
Press [ENTER].
INPUT
ADJ. VALUES
4.
View the printed test pattern, and then determine the correction value.
Select the value that gives the least misalignment between the two lines. In the case of the fol-
lowing figure, select "-3." When you cannot choose between two sequential numbers, select a val-
ue that is between them (you can set correction values in units of "0.5").
5.
Press [▲] or [▼] to select the correction value.
MEDIA GAP ADJ.
-4
6.
Press [ENTER] to confirm your entry.
7.
Press [◀] to select "SET".
REDO ADJ.?
[YES]
8.
Press [ENTER] to confirm your entry.
The test pattern is printed again. Check that the misalignment is the smallest for the figure indi-
cated by "
ure, return to step 5. to perform the setting again.
If you do not need to change the correction value, press [ENTER] again.
9.
Press [▶] to select "DONE".
104
Printing and Cutting Method
NEXT
-3
DONE
" (that is, the current correction value). If the misalignment is smaller for another fig-