Table of Contents
Advertisement
SECTION THREE
3.2 TE S TI N G N ET WO RK S T R EN G T H
Your GO alarm pendant will test the strength of your
connection to a cellular network. Your pendant will then
announce:
• "Checking cellular connection."
Your GO alarm pendant will check the cellular coverage of
its location and will announce after a few seconds:
"My connection ..."
"... is excellent"
"... is good"
"... is poor"
"... is unavailable"
A "good" or "excellent" cellular connection is required for
cloud connects and updates, which are only initiated when
your GO alarm pendant is placed on the charger.
If the connection "...is unavailable" your GO alarm pendant
will not try to obtain its current GPS location as it will have
no way of sending this information. The system check will
finish at this point.
TA KI NG CA R E
!
If you are struggling to
find a position with a
strong cellular network
connection, please
contact us on:
0800 077 8408 and we
will be happy to help.
3.3 TESTI NG LOCATI ON
If a successful cellular network check has been completed
your GO alarm pendant will then check if its GPS
coordinates can be obtained and will send coordinates to
the GPS mapping software.
Please be aware it will be flashing blue whilst doing so and
this could take as little as 15 seconds and up to 5 minutes.
Once the check has been completed, your GO alarm
pendant will announce:
LOCATION STATUS
Finding your location...
SUCCESSFUL
"... current location has been sent"
UNSUCCESSFUL
"... location check unsuccessful"
Following either of these announcements the system
check will end and your GO alarm pendant will resume
its standard function, no lights should be visible and the
sounds will cease.
If at any time you need to cancel the system check,
!
press and hold one of the buttons on either side of
your GO alarm pendant. A voice message will play,
and the light ring will flash red to let you know that
this function has been, "CANCELLED."
SECTION THREE
40
Advertisement
Table of Contents
