Taking Care GO Setup & User Manual page 14

SECTION TWO
Step Two
TU R N I N G O N T HE P OW ER
• Ensure the mains power wall socket is switched OFF.
• Plug in the power adapter. Thread the cable through the
small hole at the back of your alarm unit and connect the
cable into the 9V DC socket on the base of the alarm unit.
• Switch the mains power ON.
• Your in-home alarm unit will start up, a chime will play
followed by a welcome message:
"Hi, welcome to Taking Care, I am your personal alarm
system. Thank you for choosing Taking Care. Before
commencing your installation it is important to ensure that
you have read the supplied installation and user guide."
TA KI NG CA R E
The voice messages will take you through the installation
process step by step. Please listen and follow the steps that
are outlined. If no action is taken a message will repeat, so
don't worry if you didn't hear it the first time.
Your in-home alarm unit will then state:
• "I am going to assist you with the install process. Please
make sure your monitoring information is set up."
You can ignore this message if you have already provided
your emergency contacts to Taking Care.
• "If there is a problem at any stage of the install process,
you can press the Cancel button to hear how to turn me
off, until you are ready to start again."
To stop the install process, turn the alarm unit off by pressing
and holding the Power button; the alarm will beep twice and
announce:
• "Keep holding to turn off."
The alarm will beep 4 times and then all the lights will go off.
Release the Power button.
Only use the power adapter supplied
!
with your in-home alarm unit.
SECTION TWO
26