NEC BladeServer Express5800 Series User Manual page 30

5 DUMP switch
Press this switch to run the memory dump.
6 LAN3 Link/Access lamp (green)
The lamp is on when LAN port 3 is connected to the network. The lamp blinks when data is
being transmitted.
7 LAN1 Link/Access lamp (green)
The lamp is on when LAN port 1 is connected to the network. The lamp blinks when data is
being transmitted.
8 RESET switch
Press this switch to reset the CPU blade.
9 LAN2 Link/Access lamp (green)
The lamp is on when LAN port 2 is connected to the network. The lamp blinks when data is
being transmitted.
10 LAN4 Link/Access lamp (green)
The lamp is on when LAN port 4 is connected to the network. The lamp blinks when data is
being transmitted.
11 ID switch
Press this switch to turn on or off the ID lamp.
12 ID lamp (blue)
The lamp identifies the CPU blade in the system. The lamp is lit by a switch or software
command.
When the recognize command is received, the lamp blinks. If you press the ID switch, the
lamp goes on.
13 Eject lever
Pull the lever to remove the CPU blade from the Blade Enclosure.
14 SUV connector
This connector sends or receives various signals.
The K410-150(00) SUV cable is connected to this connector.
General Description 2-5