NEC BladeServer Express5800 Series User Manual page 268

B-10 Installing the Operating System
Installation of Windows Server 2003 R2
Install Windows Server 2003 R2 in the following procedure:
1.
Insert the Windows Server 2003 R2 CD-ROM into the DVD-ROM drive.
2.
Turn on the CPU blade.
3.
Press F6 when the message "Setup is inspecting your computer's hardware
configuration..." appears at the top of the screen.
NOTE:
Use the keyboard only when the USB floppy disk drive is not being
accessed (the access lamp is off).
The following steps are not required if F6 is not pressed.
Refer to the "First Step Guide" for details.
4.
When the following message appears, press S:
Setup could not determine the type of one or more mass storage
devices installed in your system, or you have chosen to
manually specify an adapter. Currently, Setup will load
support for the following mass storage devices.
The following message appears:
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
* Press ENTER when ready.
5.
Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into the
floppy disk drive and press Enter.
A list of the drivers for the mass storage devices is displayed.
6.
Select [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)] and
press Enter.
If a message appears, press S.
Then, it returns to the screen of Step 4.
7.
If an optional device is installed, press S again.
8.
Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into the
floppy disk drive and press Enter.
A list of the drivers for the mass storage devices is displayed.