NEC BladeServer Express5800 Series User Manual page 163

5-26 Installing the Operating System with Express Setup
4.
Specify "Complete memory dump" and enter the location where debug information is to
be written in the text box.
When writing debug information under the file name "MEMORY.DMP" in the D drive:
D:\MEMORY.DMP
5.
Click [Settings] in the [Performance] box.
The [Performance Options] window appears.
6.
Click the [Advanced] tab on the [Performance Options] window.
7.
Click [Change] in the [Virtual memory] box.
8.
Change the value set for [Initial Size] in the [Paging file size for selected drive] box to the
[Recommended] value or more, and then click [Set].
IMPORTANT:
Be sure to set the paging file size to more than the
[Recommended] value in the operating system partition. If a value
smaller than the [Recommended] value is set for [Initial Size] of
the paging file, accurate debug information (memory dump) may
not be collected.
For more information on the "Recommended" value, see "About
the System Partition Size" described earlier.
If the memory is expanded, reset the paging file size according to
the memory size.
9.
Click [OK].
A message is displayed asking you to restart the system depending on the settings changed.
Restart the system according to the message.