Nextar ME Software Instruction Manual page 82

Button Description
The Cursor is added to the active route as an
intermediate route point, a point to be reached
before the destination. If there is already a via
point in the route, the Edit Route screen opens
to let you decide where the new via point is to
appear in the route.
If the Cursor is at or near one of the via points,
this button replaces the previous one, and
deletes the selected via point from the route.
The route is recalculated without the deleted
point.
The Cursor is appended at the end of the route
as the new destination. The previous
destination is demoted, and becomes the last
via point.
This button is similar to the
button, but a new screen opens, and the route
is calculated with all the possible route
calculation methods (Fast, Short, Economical
and Easy). Observe the results, and choose
one of the routes to navigate.
The Cursor becomes the start point of the route.
This means that the route is not started from the
current GPS position, and Automatic Off-route
Recalculation needs to be turned off to keep the
selected point as the start point.
If the Cursor is at or near the selected start
point, this button replaces the previous one and
deletes the start point from the route. The
current GPS position is used again as the start
point, and Automatic Off-route Recalculation is
re-enabled.
The Cursor is saved as a user POI. Select the
POI group and give a name for the POI, then
81