Trailing Arm Spherical Bearing Replacement - Polaris RZR XP Turbo Service Manual

STEERING / SUSPENSION
9. Rotate bearing by hand and check for smooth
rotation. Visually inspect bearing for moisture, dirt, or
corrosion. Replace bearing if moisture, dirt, corrosion,
or roughness is evident.
10. Remove the four fasteners
line retainers to the trailing arm.
11. Remove the lower stabilizer bar linkage fastener.
Discard the nut.
12. Support trailing arm with suitable jack stand or
support.
13. Remove the lower shock bolt. Discard the nut.
14. Remove the front trailing arm bolt
15. Remove trailing arm from vehicle. Visually inspect
trailing arm, bushings, o-rings and spherical bearing
for wear.
16. Replace trailing arm if physically damaged.
17. Reverse this procedure to reinstall rear trailing arm.
Use new fastener nuts upon installation of the rear
trailing arm and bearing carrier.
18. Torque all fasteners to specification.
8.18
u
that secure the brake
i
. Discard the nut.
NOTE
TORQUE
Trailing Arm to Main Frame:
70 ft-lb (95 Nm)
Rear Shock Mounting Bolts:
70 ft-lbs (95 Nm)
Rear Stabilizer Bar Linkage:
42 ft-lbs (57 Nm)
Inner Radius Rod Mounting Bolts:
50 ft-lb (68 Nm) + 45°
Outer Radius Rod Mounting Bolts:
50 ft-lbs (68 Nm) + 90°
Bearing Carrier to Trailing Arm Bolts:
42 ft-lb (57 Nm)
Rear Brake Caliper Mounting Bolts:
46 ft-lbs (62 Nm)
Rear Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)
Wheel Nuts:
120 ft-lbs (163 Nm)
19. After rear trailing arm installation, test vehicle at low
speeds before putting into service.
TRAILING ARM SPHERICAL BEARING
REPLACEMENT
1. Remove trailing arm (see Chapter 8 – Trailing Arm
Removal / Installation, page
2. Remove bushings and O-rings.
3. Remove snap ring
bearing.
4. Properly support the trailing arm and press the
spherical bearing out of trailing arm casting.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
).
q
that retains the spherical
© Copyright Polaris Industries Inc.