Driven Clutch Service; Driven Clutch Removal - Polaris RZR XP Turbo Service Manual

PVT SYSTEM

DRIVEN CLUTCH SERVICE

DRIVEN CLUTCH REMOVAL

q
1. Loosen the clamp
the outer clutch cover.
2. Remove the eight screws
clutch cover.
3. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
Angle the rear of the clutch cover up and use a slight
rocking motion to work the clutch free when removing
the cover. There will be very little clearance.
4. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
5. Insert clutch spreader tool
and turn the tool clockwise to open the sheaves on
the driven clutch.
The driven clutch spreader tool is included with the
vehicle's tool kit
6. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
5.14
retaining the PVT inlet duct to
w
that retain the outer
NOTE
e
into the driven clutch
NOTE
7. Remove the driven clutch retaining bolt
8. Remove the snap ring
u
bearing .
9. Remove the driven clutch from the transmission input
shaft by holding both sheaves together and pulling
straight off.
CAUTION
The driven clutch is held together by the snap ring that
was removed in the previous step. The driven clutch will
become damaged if it is dropped.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
r
.
t y
, thrust washer and thrust
© Copyright Polaris Industries Inc.