Polaris RZR XP Turbo Service Manual page 114

ENGINE / COOLING SYSTEM
7. Remove the four fasteners
shield above the valve cover.
Front fasteners are plastic rivets and rear fasteners are
bolt/washer/nut.
8. Remove the two fasteners
to the exhaust pipe / turbo joint.
9. Remove the four fasteners
pipe to the turbocharger.
10. Remove the exhaust pipe from the chassis.
3.22
t
retaining the heat
NOTE
y
retaining the heat shield
u
retaining the exhaust
11. Remove turbocharger oil drain hose and inspect. If
the inner diameter has been deformed or obstructed,
or if any kinking or cracking is present, place the
hose.
Ensure the oil drain hose located between the
turbocharger and oil pan is not kinked or obstructed in
any way.
12. Inspect for any oil seepage or leaking from either end
of the oil drain hose. Check tightness and condition of
both hose spring clamps
13. With the use of a flashlight, inspect the compressor
q
housing inlet and compressor wheel
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
NOTE
i
. Replace if necessary.
w
.
© Copyright Polaris Industries Inc.