Cassette Pickup Solenoid; Removing The Cassette Pickup Solenoid; Paper Feed Roller; Removing The Cassete Feed Roller - Canon LASER CLASS 810 Service Manual

Chapter 8
[1]
2) Remove the snesor cover plate [1].
- Claw [2] 1pc.
[1]
3) Remove the cassette paper sensor [1].
- Connector [2] 1pc.
[1]

8.6.4 Cassette Pickup Solenoid

8.6.4.1 Removing the Cassette Pickup Solenoid

1) Remove the rear cover, left middle cover, and left rear cover.
2) Remove the relay PCB, registration clutch, and pickup drive unit.
3) Remove the the cassette pickup solenoid [1].
- Gear[2] 1pc.
8-8
[2]
[2]
F-8-11
[2]
F-8-12
[2]
F-8-13
- Screw [3] 1pc.
[2]

8.6.5 Paper Feed Roller

8.6.5.1 Removing the Cassete Feed Roller

1) Remove the cassette.
2) Place the machine with the rear panel down. However, since the exhaust
duct projects about 18 mm from other area of the rear panel, insert stacks
of paper or the like under the rear panel so that the machine stands stably.
3) While pressing the separation roller [1] to release the pressure, remove the
boss [2] and slide the feed roller upward until the shafts [3] are separated.
4) Pull out the feed roller [4] to remove it.
5) Remove the feed roller [1].
- Bushing [2] 1pc.
- Shaft [3] 1pc.

8.6.6 Manual Pickup Roller

8.6.6.1 Removing the Manual Pickup Roller

0017-3129
1) Remove the rear cover, left middle cover, and left rear cover.
2) Flex the center and remove the roller cover [1].
- Screw [2] 1pc.
- Claw [3] 1pc.
- Plugging part [4]1pc.
[3]
[1]
F-8-14
[2]
[1] [3]
F-8-15
[3] [2] [1]
F-8-16
0017-3130
[4]
0017-3131