Running Single Tests
The tester's single test mode (SINGLE TEST on the rotary
switch) lets you run individual tests for isolating cabling
failures and quickly testing repairs. You can run some single
tests without a remote. Table 3-4 shows which tests require
a smart remote.
Certifying Twisted Pair Cabling
Single tests use the selected test limit to produce a PASS/
FAIL result for the test. Each single test also produces results
for other measurements. For example, the wire map test
also produces propagation delay and delay skew results. To
see these results, press
then press
View Results.
To save a single test, press
then press
again.
Running Single Tests
when the single test is finished;
, select or create a cable ID;
3
3-33