DTX-1500 CableAnalyzer
Technical Reference Handbook
Warning
Under no circumstances is this product intended
for direct connection to telephony inputs,
systems, or equipment, including ISDN inputs.
Doing so is a misapplication of this product, which
could result in damage to the tester and create a
potential shock hazard to the user.
Service Calibration Period
One year.
Standard Link Interface Adapters
6A/Class E
channel adapters
A
Plug type and life: shielded 8-pin modular (RJ45);
>5000 insertions
Tests supported: shielded and unshielded cable, TIA Cat
3, 4, 5, 5e, 6, 6A and ISO/IEC Class C, D, E, and E
channels
Cable Types Tested
Shielded and unshielded twisted pair (STP, FTP, SSTP,
and UTP) LAN cabling:
TIA Category 3, 4, 5, 5e, 6, and 6A: 100
ISO/IEC Class C and D: 100 and 120
9-10
A
For availability of additional adapters that allow
testing to other performance standards and
different cabling types, contact Fluke Networks.
Time for Autotest
Time for a full, 2-way Autotest of Category 6 UTP cable: 9
seconds
Tone Generator Specifications
Generates tones that can be detected by a tone probe, such
as a Fluke Networks IntelliTone
generated on all pairs.
Frequency range of tones: 440 Hz to 831 Hz
Summary of Performance Specifications
All specifications for tests on twisted pair cabling
apply to 100
cable. Contact Fluke Networks for
information on measurement performance for
cable with a different impedance.
For Category 6/Class E test modes or below, the DTX
CableAnalyzer is compliant with Level III requirements of
TIA-568-C.2-1 and IEC 61935-2.
Note
™
probe. The tones are
Note