Plots; Automatically Re-Scaling Plots; Manually Re-Scaling Plots - Fluke VT Plus HF Operator's Manual

VT Plus HF
Operators Manual

Plots

Automatically Re-scaling Plots

By default, VT for Windows attempts to re-scale plots so that the entire plot is visible.
When a re-scale occurs, the high- and low-ranges on the plots are determined by the min
and max statistics for the signal shown on the plot. The monitor plots and the single plot
are re-scaled every time they reach the end of the plot. The loop plots are re-scaled on
every breath.
Automatic re-scaling may be turned off by unchecking the box next to the plot name in
the Plots, Scaling, Auto-Scale menu, as shown below.
Auto-scaling is automatically turned off for a plot if the plot is manually re-scaled. Auto-
scaling can also be turned off by right clicking on a plot and unchecking the Auto-Scale
option.
Selecting the Plots, Scaling, Auto-Scale function, or clicking the Re-Scale Now
button on the tool bar forces an automatic re-scale to occur immediately.

Manually Re-scaling Plots

There are two ways to specify a specific range to view on a plot:
•
4-28
Select Scaling and Manual Scale from the Plots menu bar, as shown below:
Then click the preferred plot. The following dialog box appears:
fec110.bmp
fec111.bmp