Advertisement
* N N O O TE TE Invalidation of the operating permit
due to failure to comply with the instruc-
tions for installation and use
The operating permit may be invalidated if the
instructions for installation and use of two-way
radios are not observed.
Only use approved frequency bands.
#
Observe the maximum permissible out-
#
put power in these frequency bands.
Only use approved aerial positions.
#
1
Front roof area
2
Rear roof area
Use Technical Speci cation ISO/TS 21609 (Road
Vehicles – "EMCs for installation of a ermarket
radio frequency transmitting equipment") when
retro tting two-way radios. Comply with the legal
requirements for detachable parts.
If your vehicle has ttings for two-way radio equip-
ment, use the power supply and aerial connectors
provided in the pre-installation. Observe the man-
ufacturer's supplements when tting.
T T w w o-wa
o-way r y radio tr
adio transmission output
ansmission output
The maximum transmission output (PEAK) at the
base of the aerial must not exceed the values in
the following table.
Fr Freq equency band and maximum tr
uency band and maximum transmission out-
put
put
F F r r eq equency band
uency band
Maximum transmis-
Maximum tr
Short wave
3 - 54 MHz
4 m frequency band
74 - 88 MHz
F F r r eq equency band
uency band
2 m frequency band
144 - 174 MHz
Terrestrial Trunked
Radio (TETRA)
380 - 460 MHz
70 cm frequency band
420 - 450 MHz
Two-way radio
(2G/3G/4G)
ansmission out-
The following can be used in the vehicle without
restrictions:
ansmis-
sion output
sion output
two-way radios with a maximum transmission
R
output of up to 100 mW
100 W
RF transmitters with transmitter frequencies in
R
the 380 - 410 MHz frequency band and a
maximum transmission output of up to 2 W
30 W
(TETRA)
mobile phones (2G/3G/4G)
R
Technical data 405
405
Maximum transmis-
Maximum tr
ansmis-
sion output
sion output
50 W
10 W
35 W
10 W
Advertisement
