Taylor-Dunn ET-3000 Manual page 88

Brakes
8. Remove the tire/wheel assembly. Refer to
the tire and wheel assembly.
9. Thoroughly clean the area around the brake body.
10. Remove the brake body bolts and discard the lock
nuts.
11. Inspect the brake rotor. Refer to
Service Brake
inspecting the brake rotor.
12. Disconnect the brake hose from the brake body.
13. Install the new brake body assembly in reverse
order.
•
Use teflon tape thread sealant on the brake hose
fitting.
•
Torque the brake body bolts to the specified amount listed in the Hardware Torque Table at
the end of this section.
14. Bleed the brakes. Refer to
brakes.
15. Set the park brake.
16. Reconnect the main positive and negative cables at the batteries.
17. Lower the wheel to the ground.
18. Remove the blocks from behind the wheels.
19. Release the park brake and test drive the vehicle.
Page 14
Tires and Wheels
Inspect the
section for information regarding
Bleed the Brakes
section for information on removing
section for information regarding bleeding the
T-48 AC / ET 3000
MB-T48-02