Taylor-Dunn ET-3000 Manual page 86

Brakes
9. Remove the tire/wheel assembly.
Note: Refer to
10. Release the park brake (wheel brake only).
11. Remove the brake body bolts and discard the lock nuts and brake pads.
12. Remove the spacer bushings from the mounting
bracket and discard.
13. Inspect the brake rotor. Refer to
Service Brake
inspecting the brake rotor.
14. Inspect the spacers and replace if any wear or
damage is found.
15. Install new spacer bushings in the mounting
bracket.
16. Back off the parking brake adjustment (wheel park
brake only).
17. Install new brake pads in reverse order. Torque the mounting bolts to the specified amount listed
in the Hardware Torque Table at the end of this section.
18. Repeat this procedure for the other wheel.
19. Install the tire/wheel assembly and lower the vehicle to the ground.
20. Fill the master cylinder to the proper level. Refer to
for information regarding the correct master cylinder fluid level.
21. Set the park brake.
22. Reconnect the main positive and negative cables at the batteries.
23. Remove the blocks from behind the wheels.
24. Release the park brake and test drive the vehicle.
Page 12
Tires and Wheels
the tire and wheel assembly.
Inspect the
section for information regarding
section for information on removing
Check Master Cylinder Fluid
T-48 AC / ET 3000
section
MB-T48-02