Replace The Tire (Pneumatic) - Taylor-Dunn ET-3000 Manual

T-48 AC / ET 3000

REPLACE THE TIRE (PNEUMATIC)

Note: To replace the tire, the tire/wheel assembly must be removed
Tire replacement should only be performed by personnel trained in tire replacement.
The tire replacement procedure will be unique to the type of replacement equipment being used. Refer
to the instructions provided with your equipment.
Always use a new valve stem when replacing a tire.
1. Remove the tire from the wheel.
2. Cut the old valve stem off of the wheel.
3. Remove the valve stem cap from the new valve stem.
4. Lubricate the valve stem with liquid soap.
5. Install a new valve stem using a valve stem tool.
Note: The valve stem tool is available at most auto repair shops.
6. Install the tire onto the wheel following the instructions provided with your tire replacement
equipment.
7. Inflate the tire to the proper pressure and check for leaks.
8. Install the valve stem cap.
MB-T48-02
from the vehicle. Refer to
information on removing the tire/wheel assembly.
Explosion Hazard. Fully deflate the tire before attempting to remove
the tire from the wheel. Do not over inflate the tire when seating
the bead. Failure to deflate the tire or over inflating the tire to seat
the bead may cause explosive failure of the tire resulting in severe
bodily injury or death.
Replace the Tire/Wheel
Tires and Wheels
section for
Page 5