Taylor-Dunn ET-3000 Manual page 141

T-48 AC / ET 3000
REPAIR/PROGRAMMING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Repairs
There are no internally serviceable components in the motor speed controllers. If a controller is faulty then it must
be replaced.
Note: Opening or disassembling a controller will void the comptroller warranty.
Programming
Taylor-Dunn does not support field modifications to the controller parameters.
Complete vehicle parameters are available by e-mail and can be uploaded to the controller using a laptop or PC
with the 1314 application and cable. Refer to the Tools section for part numbers.
If you have a special application that may require modified parameters, contact your local authorized Taylor-Dunn
distributor to submit a request to the factory. Note: There may be a fee to created a custom parameter set.
Instructions for obtaining parameter sets and how to upload to the controller are included with the application.
HARDWARE TORQUE
If hardware is not listed here, refer to standard torque
values in the appendix.
Description
Terminal stud
MB-T48-02
Inch Pounds Newton Meters
85 9.6
Motor Controller
Page 3