Tire Inflation; Tire Inspection - Taylor-Dunn ET-3000 Manual

Tires and Wheels

TIRE INFLATION

There are many tire options available with varying tire
pressures. Refer to the side wall of your tire for information
regarding the tire pressure for your tires.
The illustration to the right is an example of the side wall
information on a tire.
Tire pressures must be checked when the tire is cold.

TIRE INSPECTION

6. Check the tire pressure. Refer to Tire Inflation
section for information on checking the tire pressure.
7. Inspect the tire tread depth. Minimum recommended
tread depth is 1/16-inch. There are a series of tread
depth wear indicators around the circumference of
the tire. They will appear as 1/2-inch bands across
the tread as the tire approaches its wear limit (see
illustration to the right). Replace the tire if any tread
depth indicator can be seen or any part of the tread
depth is 1/16-inch or less. Refer to Replace the Tire
section for information regarding replacing the tire.
Page 2
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
T-48 AC / ET 3000
MB-T48-02