Taylor-Dunn ET-3000 Manual page 144

Chargers
REMOVE/INSTALL
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
HIGH VOLTAGE.
Disconnect the batteries and make sure that the AC
power cord has been unplugged before disconnecting
any wires or removing the cover of the charger.
Failure to follow this instruction may result in serious
injury due to electric shock and/or property damage.
There are many charger options available for this
model. The different charger may have different wiring
connections.
Disconnect the batteries and make sure that the AC
power cord has been unplugged before disconnecting
any charger wires or cords.
Some charger models have disconnects close to the
charger and some have full length wire and molded
cords. When replacing chargers with full length wires and
molded cords, DO NOT cut and splice the wires or cord.
Cutting the wires or cord will void the charger warranty
and may result in incorrect operation of the charger or
premature failure.
Page 2
TROUBLESHOOTING
Troubleshooting control system is not included in this
manual.
All electrical troubleshooting information is included in
a separate manual "Troubleshooting Electric Vehicles".
The manual part number is M7-001-69 and was provided
on the original vehicle CD. A hard copy can be purchased
from your authorized Taylor-Dunn distributor or can be
downloaded from the Taylor-Dunn web site.
T-48 AC / ET 3000
MB-T48-02